Aerovox is a leading manufacturer of AC film capacitors, located in
Baker
Engineering & Controls provided:
· Engineering, Design & Fabrication of the
Cooling Tunnel capable of cooling down load of 1,200 lb of degreased capacitors from 160°F to ambient temperature with conveyer speed
of 2 ft/min
· Design/Built Project to perform installation of two (2) fire tube steam
boilers, constructed for 150 psig steam pressure and all necessary auxiliary equipment, including:
o Feed Water Pumps.
o Packed Column type Deaerator
o Blowdown Separator.
o Automatic twin cation resin softening system
o All necessary steam, natural gas and city water piping and fittings
· Design/Built
Project to perform installation of Process Cooling Water System, including:
o Water Cooled
Chillers.
o Water Cooling Tower
o Free Cooling
Plate & Frame Heat Exchanger
o Centrifugal Pumps and all necessary Water Specialties,
Valves and Piping
o Chemical Treatment System
· Design/Built Project to perform installation of Process Heating Water System, including:
o Steam/Hot Water Shell & Tube Heat Exchanger
o Centrifugal Pumps and all necessary Water
Specialties, Valves and Piping
· Engineering, Design, Fabrication and Installation
of Exhaust and Make-up Air Systems for the following:
o Wet-Met Equipment
o Dry-Met Equipment
o Fill-Holes Soldering Station
o Mechanical, Oil Storage and Oil Impregnation Areas.
· Engineering, Design, Fabrication
and Installation of Zinc Spray Exhaust, Make-up Air and Steam Humidification Systems including:
o Fabrication and installation of all necessary exhaust hoods for spray systems and auxiliary equipment.
o Furnishing and installations of necessary ductwork to connect all exhausts to the existing dust collectors.
o Furnishing and installation of reheat coils for make-up air and all necessary ductwork to provide make-up air to spray booth location.
o Furnishing and installation of steam humidifiers and necessary control to maintain 30-35% humidity level at spray booth locations
o Furnishing and installation of all necessary steam, condensate and glycol pumps, piping
and fittings.
· Engineering, Design, Fabrication and Installation of Impregnating
Oil Distribution System including:
o Furnishing and installation of all necessary oil, vacuum,
steam, condensate, cooling and hot water piping and fittings.
o Furnishing and installation
of all necessary pressure and temperature regulators, control and isolation valves
o Furnishing
and installations of necessary instrumentation
o Furnishing and installation of all necessary
piping insulation and heat tracing.
